Wika LSD-30 Bedienungsanleitung PDF herunterladen (Seite 20)

20 WIKA operating instructions level switch model LSD-30

Parameter Description

SP1/SP2 Hysteresis function: Switch point switching output (1 or 2)

FH1/FH2 Window function: Window high switching output (1 or 2)

RP1/RP2 Hysteresis function: Reset point switching output (1 or 2)

FL1/FL2 Window function: Window low switch output (1 or 2)

EF Extended programming functions

RES Return the set parameter to the factory settings

DS1/DS2 Switch delay time, which must occur without interruption before any electrical signal change occurs

(SP1 or SP2)

DR1/DR2 Switch delay time, which must occur without interruption before any electrical signal change occurs

(RP1 or RP2)

OU1 Switching function switching output (1 or 2)

OU2 HNO = hysteresis function, normally open

HNC = hysteresis function, normally closed

FNO = window function, normally open

FNC = window function, normally closed

UNIT Changing units

SETR

Measuring range scaling (analogue output)

"4 mA" or "0 V" determines at which level the output signal is to be 4 mA or 0 V.

"20 mA" or "10 V" determines at which level the output signal is to be 20 mA or 10 V.

OFS Oset adjustment by 1,500 mm maximum (distance between start of measuring range and tank

bottom). Not possible with unit "%".

DISM Display value in display mode

ACT = actual level; LOW, HIGH = minimum, maximum level value OFF = display o;

SP1/FH1 = function switch point 1, RP1/FL1 = function reset point 1,

SP2/FH2 = function switch point 2, RP2/FL2 = function reset point 2,

DISR Rotate display indicator by 180°

RHL Clear the Min- and Max-value memories

PAS Password input, 0000 = no password, password input digit by digit

TAG Input of a 16-gure alphanumeric measuring point number

11613033.01 01/2012 GB/D/F/E

6. Commissioning, operation

6.4 Parameters

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 103 104

Keine Kommentare

Wika LSD-30 Bedienungsanleitung Seite 20