Wika WU-26 Bedienungsanleitung PDF herunterladen (Seite 17)

17WIKA Operating instructions/Betriebsanleitung/Mode d'emploi/Instrucciones de servicio, WU-2X

11553678.02 GB/D/F/E 10/2012

8. Adjustment of zero point

The UHP-Transducers are maintenance free. The transducer is factory calibrated and does not normally need

eld adjustment.

WARNING!

For equipment with Ex nA nL marking, or if operated under nA nL conditions: Do not separate

when energised.

For verication and adjustment of the zero point, vent the transducer to zero (0)PSI for gage reference trans-

ducers. Use a 0.040" to 0.060" (1 to 1.5 mm) jeweler's screwdriver for adjustment.

■

For instruments with absolute pressure measuring ranges or +/- measuring ranges, a

sucient calibration equipment as well as a vacuum pump are also necessary for the zero

point adjustment.

■

Span adjustment is not necessary after zero point correction.

Procedure

1. Restore power to the transducer.

2. Lift the sticker.

3. Adjust the zero point by means of the potentiometer

in pressureless state. Check the zero point by means

of a suitable instrument. Clockwise rotation means an

upward zero oset, anti-clockwise rotation means a

downward zero oset.

4. Push the sticker on.

For further information

(+49) 9372/132-8976

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 83 84

Keine Kommentare

Wika WU-26 Bedienungsanleitung Seite 17