Wika CPH6300 Bedienungsanleitung PDF herunterladen (Seite 27)

6 Commissioning, Operation

WIKA Operating Instruction, Model CPH6300 27

14043054.01 07/2012 GB/D

6.9 Pressure connection to the sensors

The device is designed to be connected to the sensors model CPT6200 without a new calibration

being necessary. Therefore a great variety of replaceable sensors of 0 ... 100 mbar relative up to

0 ... 1000 bar pressure can be connected to the device.

Reference pressure sensors model CPT6200

For measurements of relative, vacuum or absolute pressure screw sensor to G1/2 pressure

connection or plug a plastic tube to a suitable adapter. Connection to CPH6300: Use sensor

connection cable.

Pressure measurements with two sensors (only 2-channel version)

Pressure differences of any sensor combinations can be measured by means of the calculation

sensor1 – sensor2 (DIF).

6.10 Alarm („AL.“)

There are 3 possible settings:

off (AL.oFF), on with buzzer (AL.on), on without buzzer (AL.no.So).

Alarm is given in the following cases (if alarm active, AL.on or AL.no.So):

■ Lower alarm boundary (AL. Lo) under-run

■ Upper alarm boundary (AL. Hi) over-run

■ Sensor error

■ Low battery (bAt)

■ Err.7: system error (always with buzzer!)

6.11 Handling the tilt stand

■ Pull the tilt stand at the marking “open” to swing out the tilt stand

■ Pull the tilt stand at the marking “open” again to further swing out the tilt stand more.

Typical Applications:

Instrument fixed on a belt

Instrument placed on a table

instrument hanging on the wall

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 59 60

Keine Kommentare

Wika CPH6300 Bedienungsanleitung Seite 27