Wika D-21-9 Bedienungsanleitung PDF herunterladen (Seite 50)

D-20-9 / D-21-9 GB

WIKA Additional Instructions Pressure Transmitter with CANopen Interface D-20-9 / D-21-9 50

Example

Configure the node-is of a slave:

• Set the device to stopped mode (see 9. Network Management Objects)

• Change from operation mode to configuration mode via Switch Mode Selective

(see LSS Protocol Descriptions)

• Setting the node ID via Configure Node-ID Protocol

(see LSS Protocol Descriptions)

• Change from configuration mode to operation mode via Switch mode Global

(see LSS Protocol Descriptions)

Configure the bit timing parameters:

• Set the device to stopped mode (see 9. Network Management Objects)

• Change from operation mode to configuration mode via Switch Mode Global

(see LSS Protocol Descriptions)

• Set baud rate via Configure Bit Timing Parameters Protocol

(see LSS Protocol Descriptions)

• Activate bit timing via Activate Bit Timing Parameters Protocol

(see LSS Protocol Descriptions)

• Change from configuration mode to operation mode via Switch mode Global

(see LSS Protocol Descriptions)

1 2 ... 45 46 47 48 49 50 51

Kommentare zu diesen Handbüchern

Keine Kommentare